Sunday, September 20, 2015

9/16 Arduino Chapter 3 lessons

Lesson 3-1 when the potentiometer is dialed, the serial reading changes





Lesson 3-2 When the temperature is in an acceptable range, the LED is green. Here, my LED is green. The first trial of this exercise I burnt my finger and melted the bread board before I even had a chance to upload the code, but the light would have obviously been red meaning it was too hot.  





It was a fail.  The Light sensor works and it detected by the serial monitor but the LED will not come on.
Lesson 3-1 Automatic Night Light

No comments:

Post a Comment